|
 |
|  |
| |||||||
| NA Tuning Discussion, problems, pitfalls, you can find everything at Pricemart! |
 |
 | Thread Tools | Display Modes |
25th August 2008, 08:43 PM
| #1 (permalink) |
| Senior Member 3,000rpm (Grandma Drag) Join Date: May 2008
Posts: 312
Location: Auckland | some questions about vafc2 tuning one of my mates told me that these controllers are tuned from 3000rpm onwards.i know that u can tune them at 200rpm increments. my question is whether they are tuned from 0 or 3000rpm as the vtec point only lowers till 3000.thx |
|  |
|
25th August 2008, 09:10 PM
| #2 (permalink) |
| Senior Member 7,000rpm (Peak Power) Join Date: May 2003
Posts: 3,548
Location: Auckland | Re: some questions about vafc2 tuning is depends how to layout the rpm range Lo throttle normally starts off a 1000 rpm or 1500rpm and goes up to 6500 depends wat spacing you use
__________________ Check out http://monstereg6.jimdo.com/index.php |
|
| |
|
25th August 2008, 09:43 PM
| #3 (permalink) |
| Member 700rpm (Idle)  Join Date: Jul 2008
Posts: 91
Location: Auckland | Re: some questions about vafc2 tuning jus get them professionally tuned.. they usually set the vtec point around 4000rpm - 5000rpm ish.. they set everything up, specifically for that car. really depends on the modifications of your car. Would cost around $300-$400.. |
|
| |
|
| Thread Tools | |
| Display Modes | |
|
|
 
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tuning vafc2 for prelude type S h22a??? | Type S | NA Tuning | 11 | 11th July 2008 05:58 PM |
| Fuel Pressure Reg essential for VAFC2 tuning? | Coupe-R | NA Tuning | 12 | 31st March 2006 01:36 AM |
| Tuning ITR with VAFC2 or Link? | RevTec | General Discussion | 28 | 30th May 2005 07:39 PM |
| Tuning BB6 Prelude - I/H/E tuning problems and solutions | robstar | NA Tuning | 39 | 13th April 2005 03:32 PM |
| header + tuning questions | 22 | NA Tuning | 57 | 4th January 2005 10:12 PM |
 |  |
Linear Mode
