NZHondas.com - View Single Post - Any one do BRE or equivalent obd0 PR3 chipping???

bmgjet · 16th July 2008, 03:57 PM

ways i have removed chips are,

Side cutters then desolder the pins left, (this has been the easyest way iv done it so far.)
hot air gun, (also was quite easy but scratched the board a bit trying to wedge the chip out)
solder wick, (was the hardest and took the longest time maby hard because my iron was a high W one)
PCB solder drill piece, (was the quickest and very easy but was quite risky to the traces.)

Ill try Moclov way next time.

16th July 2008, 03:57 PM	#46 (permalink)
bmgjet Senior Member 6,000rpm (Max Torque) Join Date: Jul 2007 Posts: 2,147 Location: New Plymouth	Re: Any one do BRE or equivalent obd0 PR3 chipping??? ways i have removed chips are, Side cutters then desolder the pins left, (this has been the easyest way iv done it so far.) hot air gun, (also was quite easy but scratched the board a bit trying to wedge the chip out) solder wick, (was the hardest and took the longest time maby hard because my iron was a high W one) PCB solder drill piece, (was the quickest and very easy but was quite risky to the traces.) Ill try Moclov way next time.